Parametric Hex Bit Storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fully parametric bit storage system for Fusion 360.
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 138
- Wydruki
- 1
- Wyświetlenia
- 487
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This parametric Fusion 360 model allows you to tailor bit storage to your specific requirements.
The main parameters are as follows:
- qty_x - number of bits in the x axis
- qty_y - number of bits in the y axis
- bit_width - the size of the hex bit with some tolerance added in (default 6.65)
- margin_x, margin_y - defines the border size (default 3mm)
- separation_x, separation_y - defines how far apart the holes are placed (default 2mm)
To access parameters, choose Modify>Change Parameters from any modelling tab.
The parameter bit_width governs how loose or tight the fit is for the bits; the default value works for me with my setup.
Note - Fusion is a bit funny about some parameter changes and fails to redraw the model correctly. In this case use CTRL-B or ⌘-B to recalculate.
Also be careful not to overtax Fusion's calculation engine - 20x20 is more than enough to bog it down, although it will still work.