Caliper Holder for Multiboard and Honeycomb Storage Wall (HSW)

This is small quick model needed for myself. First intension was to print a ready model, but as it happens, best one I liked a little bit didn't met my taste. The models (which was already a remix) author made it with attached Multiboard snap as it found a Push fittings too loose. Somehow I see opposite. I'm a bit disappointed in Multiboards snaps as at least in my case are way too loose. Probably Tight  ones are good, but haven't checked them yet. But push fittings are tight and strong. And as I have built my multiboard wall to be able to make things for Multiboard as well as for HSW I usually do, this time I made a 2 versions as well. Multiboard and HSW ones. Both are push in types and goes to both walls the same as shown in those 2 renders for HSW:
 

The blue is insert-empty.stl from original HSW model by rostap. Same as for Multiboard, just use a Multiboard Snap (I think Multiboard Tight Snap would be better, but can't confirm it yet). You can use a Glue if you want (but absolutely not necessary) when putting Holder and Pin together.  Supports not needed at all. Should be quick and easy print. 

You can Buy me a coffee if You want to support me in my work here :)

https://www.buymeacoffee.com/warlogh

(And very Big Thank You For interest in my work)