Bike Computer Stem Mounts - Wahoo and Garmin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stem mounts for Garmin or Wahoo bike computers designed to be printed in TPU.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 174
- Wydruki
- 0
- Wyświetlenia
- 1262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I was tired of my 3D printed bike computer mounts breaking so I designed mounts to be made out of TPU. After several test designs, I settled on two mounts to connect to the stem or the top cap. Both designs have been tested on my mountain bike for several months never having the computer pull out of the mount. That said, I always use a leash on the computer so i would never lose a computer regardless how bad a crash might be.
These are designed to be printed in TPU which makes them almost indestructible compared to PETG or PLA. I print them flat on the bed using tree supports which make removing supports much easier than normal supports. I also use 100% infill and iron the top to make it look smoother. You are welcome to print out of any material you like as they would work as well. I just prefer TPU.
For those that think having a TPU stem cap is not as safe as a normal cap and spacer, you are probably right. However, the stem cap is only needed to remove play in the fork and frame when installing a stem. The cap has little to nothing to do with keeping the stem connected to the steerer tube once the stem is tightened down.