Wolverine Reflecta F2D Adapter for 7-inch Reels 8mm Super8 Digitizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Wolverine F2D Film Digitizer handles up to 5-inch reels of 8mm or Super8 film. This allows you to use 7-inch reels
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 67
- Wydruki
- 0
- Wyświetlenia
- 460
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
The Wolverine F2D Film Digitizer handles up to 5-inch reels of 8mm or Super8 film. This allows you to use 7-inch reels.
I saw other setups here and found them to be complex and require bearings, wood, screws, clamps etc. This one uses only 3D printed objects - with one part being TPU if you don't have a large enough rubber band on hand.
See the pictures to put it together.
Print all parts in 0.3 layers of PLA at 20% infill except:
Print the DRIVE BELT in TPU or use a large rubber band
Supports required for:
REEL HUB
BASE
ARM
Potential Tweaks:
I found it was more reliable with more tension on the drive belt. If you need more tension for the drive belt, tie a rubber band around the top of the arm and hang something from it. I used a tape measure. A wide take-up reel that isn't warped will help too.
This device is really slow for rewinding. 7-inch reels only make it worse. I use a projector to make quick work of it. You could create a larger drive hub for rewinding if you want - just like changing gears on a bicycle.
The pin holding the take-up reel is quick and dirty. I don't think the reel will fall off without it.
I didn't put much time into it. Perfection is the enemy of good enough, but a snap-fit end and direct reel mounting would work too.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Filament: Any PLA + TPU
Category: Camera
