1 / 9
Wolverine Reflecta F2D Adapter for 7-inch Reels 8mm Super8 Digitizer — image 1
1 / 9

Wolverine Reflecta F2D Adapter for 7-inch Reels 8mm Super8 Digitizer

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The Wolverine F2D Film Digitizer handles up to 5-inch reels of 8mm or Super8 film. This allows you to use 7-inch reels

Rating
0 / 5
Likes
6
Downloads
67
Makes
0
Views
460
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

The Wolverine F2D Film Digitizer handles up to 5-inch reels of 8mm or Super8 film. This allows you to use 7-inch reels.

I saw other setups here and found them to be complex and require bearings, wood, screws, clamps etc. This one uses only 3D printed objects - with one part being TPU if you don't have a large enough rubber band on hand.

See the pictures to put it together.

Print all parts in 0.3 layers of PLA at 20% infill except:

Print the DRIVE BELT in TPU or use a large rubber band

Supports required for:

REEL HUB

BASE

ARM

Potential Tweaks:

I found it was more reliable with more tension on the drive belt. If you need more tension for the drive belt, tie a rubber band around the top of the arm and hang something from it. I used a tape measure. A wide take-up reel that isn't warped will help too.

This device is really slow for rewinding. 7-inch reels only make it worse. I use a projector to make quick work of it. You could create a larger drive hub for rewinding if you want - just like changing gears on a bicycle.

The pin holding the take-up reel is quick and dirty. I don't think the reel will fall off without it.

I didn't put much time into it. Perfection is the enemy of good enough, but a snap-fit end and direct reel mounting would work too.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

Yes

Filament: Any PLA + TPU

Category: Camera

Tags