HTRC Smart Charger Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recently did a CHINS upgrade on my RM480EX and needed a new home for the new charger
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 53
- Wydruki
- 1
- Wyświetlenia
- 283
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple bracket (print 2) to hold your HTRC Smart charger (or similar) to the wall. I ended up rotating the charger up 45 deg so I could see the display better when standing by the mower. Its a simple design, print on the side and you'll want supports for the key holes for the wall screws. There is a clip for power cable management. I didnt want my power cable getting snagged on anything in the garage and the gap under the charger holds the Delta Connector just fine when the charger isnt in use.
I printed mine in in PLA+ with a strong profile and the bracket was able to bend to accommodate the charger without snapping.