SEVERIN 71 series vacuum 35mm accessory adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter allowing the use of 35mm vacuum accessories with the handheld SEVERIN 71xx vacuum with proprietary inlet
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
One of the pieces included with the vacuum is supposed to work as an adapter, but it's so thin and slightly oversized that it feels like it might break when mounting an accessory. This model, however, is much sturdier and connects well on both sides. The alignment protrusion and locking groove are designed to clip in place just like the original parts. The press-fit side? Well, it’s a press fit, simple as that.
Off-brand parts for “lower tier” karcher vacuums should all fit, and those are cheap and come in a plenty of shapes.
Warning: the side touching the buildplate has a sacrificial layer (internal brim), cut it with a deburring knife or break off with your fingers, it's there to prevent spaghetti monsters from eating up your filament
(And yes, since it's only about a 35-minute print, I just trial-and-errored it until it literally clicked into place. Source .blend is attached if you want to mess with it some more)