Drywall grid alternate layers Optimized for slicing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original drywall grid is good, but cannot print well after its sliced as it tries to do little rectangles.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 111
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model prints well with PETG and just 3 layers at 0.3mm layer thickness does the trick. The grid comes off just stiff enough and bendy to be inserted into wall and snap back to flat.
A brass wire or screw can be attached to grid to prevent it from falling into the wall while installing. Using some power grab or construction adhesive after its inserted into wall is easy to do by moving the wire or screw attached to grid around. Then pull on the wire/screw and tie off to a piece of cardboard or wood from front of wall and allow glue to dry overnight.
Then remove wire/screw and apply spackling patch in 2 or 3 applications and allow the spackling to key into the grid for a solid patch.
This worked really well on my textured wall where I did not want to cut out a rectangular patch and back it up with wood and new drywall. No amount of texturing would have been able to hide straight cut lines. This patch let me keep the opening organically shaped and a bit of scotch brite pad dipped into spackling mimicked the texture good enough.