MN78 1/12 scale rear bumper with tire carrier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A rear bumper drop-in replacement that can be printed for your MN78 rc model!
- Ocena
- 4 / 5
- Polubienia
- 24
- Pobrania
- 166
- Wydruki
- 1
- Wyświetlenia
- 948
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is my second, and last rear bumper for the MN78 model. I plan on updating this model as needed so suggestions and feedback are welcomed. The bumper features a swing-open tire carrier, two shackles/mounts and a hitch receiver. In the pictures above, the jerry can is printed at 50% of it's original size, and the high lift jack is printed at 60% of it's original size.
The new and updated hitch (mn78_hitch.stl) is compatible with this 1:12 and 1:16 scale 14K Deckover (flatbed) trailer. Whereas the older hitch (mn78_rearbumper_hitch.stl) can be used for decoration.
Required Hardware:
Tire Carrier wheel mount: use original tire screw or any 1x M2.5x10mm or longer
Tire Carrier to bumper mechanism: 1x M2x10mm
Shackle and Hitch receiver: 3x M2.5x8mm
Optional Hardware (hitch assembly):
If you plan on printing mn78_hitch.stl, you will also need:
1x 5x2mm bead. Note: not all beads are the same size (these are not very precise). Find one that "clicks" nicely with the receiver.
2x M2 nuts
Printing Notes:
Everything pictured was printed at 0.2mm on a 0.4mm nozzle
I've oriented the parts in the direction which I found the easiest to print from.
The bumper will need supports
Use supports lightly on the tire carrier part, the mesh is thin and easily broken when removing support. This part is hands down the hardest to clean
Hitch and Hitch stub can be printed without support
Shackles is best printed with "support on build plate only"
I've printed mine out of PETG, but would recommend PLA as well.