Gridfinity Nikon Z mount lens holders

Nikon Z mount lens holder for the gridfinity system. There are 2x2 and 3x3 versions of this holder depending on the diameter of your lens. The 2x2 is great for leaving a space between lenses and printing out a 1x2 cf express, sd card, or other accessory holder. I found the 3x3 holds the Nikon Z 85mm f1.2 with just a little bit of the lens hood extending past the edge of the holder. I was not able to use @jonlarson's awesome holder due to many of my lenses being larger.

There are 4 slots in the top of the design to accommodate the indexing tab on the Nikon Z lens rear cap. The lenses do not fit very snug but this makes inserting a bit easier and prevents the holder from coming out of a thin gridfinity base.

I printed mine out in PETG .6mm @ .2mm layer height with 10% infill. I had some top surface inconsistency but that could be fixed by extra top layers or more infill. I also changed the chamfer to be consistent between the two sizes but the pictures have one of the design iterations with a larger chamfer. Feedback and comments welcome!

Check out my horizontal lens holder for telephoto zooms for gridfinity here.

Update: Added a 4x4 version to give more room between the 85mm 1.2 and other lenses.

10/7/24 Update: Added 6mm x 2mm magnet recesses and 10mm deep M3 holes to address feedback where the trays were easily coming out of the grid.