Parametric Bit Driver (hex 2mm to 10mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Since i have not found any good driver for 4mm bits i made one myself. Done in OpenSCAD, source provided.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 209
- Wydruki
- 1
- Wyświetlenia
- 948
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Since i have not found any good driver for 4mm bits i made one myself. Done in OpenSCAD, source provided.
Inside is an hole for a magnet (4mm diameter, 2mmheight). Magnet should just hold by pressfiting, otherwise use glue.
Tolerances work well for Prusa MK2/MK3, but maybe you have to adjust.
Edit: you seem to like this one, so i made it parametric (including customizer support). You can now generate hex drivers for 2mm up to 10mm - including different magnet-sizes.
Print instructions
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 15% - 20%
Notes: Print with Brim. (4mm+)