Parametric Bit Driver (hex 2mm to 10mm)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Since i have not found any good driver for 4mm bits i made one myself. Done in OpenSCAD, source provided.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 209
- Makes
- 1
- Views
- 948
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Since i have not found any good driver for 4mm bits i made one myself. Done in OpenSCAD, source provided.
Inside is an hole for a magnet (4mm diameter, 2mmheight). Magnet should just hold by pressfiting, otherwise use glue.
Tolerances work well for Prusa MK2/MK3, but maybe you have to adjust.
Edit: you seem to like this one, so i made it parametric (including customizer support). You can now generate hex drivers for 2mm up to 10mm - including different magnet-sizes.
Print instructions
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 15% - 20%
Notes: Print with Brim. (4mm+)