1 / 8
Enclosure -  WiFi module for Bestway Lay-Z-Spa hottub — zdjęcie 1
1 / 8

Enclosure - WiFi module for Bestway Lay-Z-Spa hottub

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Case for custom-made PCB for controlling your hot tub from Bestway via mobile or Smart Home system

Ocena
5 / 5
Polubienia
15
Pobrania
308
Wydruki
2
Wyświetlenia
1766
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is an enclosure for Wifi module based on PCB_V2B made by @visualapproach

Project can be found here: https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA 

It is heigh enough to fit ESP module mounted on headers, additionally can be made more water tight by adding a sealing (it has cut out for sealing rod, 1,75mm soft TPU filament can be used). On bottom has 4 cuts for cable strips ties, for better mounting/attachment.  

 

Materials:

  • Hex screw M3x20 and M3 nut - 4 pc. - for putting case together
  • Screw M3x4 (alike hard drive mounting screw) - 2 pc. - for holding PCB in place

 

Optionally, if pump is placed outdoors or in wet environment:
  • About 30cm of soft TPU filament (or rubber seal Ø1,75mm) - for sealing rod
  • Piece of Armacell 3mm sealing tape or similar, alternative silicone - for sealing around cables 

 

Dimensions:

Outer dimension: 112,6mm x 79mm x 27mm

Inner height for PCB: 19,5mm

 

Print instructions:

Material: PETG or ABS, 

0,2mm layer height, holes for screws may need some support.

 

Enjoy! :) 

 

Tagi