Enclosure - WiFi module for Bestway Lay-Z-Spa hottub
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for custom-made PCB for controlling your hot tub from Bestway via mobile or Smart Home system
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 308
- Makes
- 2
- Views
- 1,766
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an enclosure for Wifi module based on PCB_V2B made by @visualapproach
Project can be found here: https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA
It is heigh enough to fit ESP module mounted on headers, additionally can be made more water tight by adding a sealing (it has cut out for sealing rod, 1,75mm soft TPU filament can be used). On bottom has 4 cuts for cable strips ties, for better mounting/attachment.
Materials:
- Hex screw M3x20 and M3 nut - 4 pc. - for putting case together
- Screw M3x4 (alike hard drive mounting screw) - 2 pc. - for holding PCB in place
Optionally, if pump is placed outdoors or in wet environment:
- About 30cm of soft TPU filament (or rubber seal Ø1,75mm) - for sealing rod
- Piece of Armacell 3mm sealing tape or similar, alternative silicone - for sealing around cables
Dimensions:
Outer dimension: 112,6mm x 79mm x 27mm
Inner height for PCB: 19,5mm
Print instructions:
Material: PETG or ABS,
0,2mm layer height, holes for screws may need some support.
Enjoy! :)