Qidi Q1 Pro - top spacer with dovetail (no gluing necessary)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The spacer prevents the PTFE tube from scratching the cover. However, as all the spacers I found were made of four…
- Ocena
- 3,75 / 5
- Polubienia
- 35
- Pobrania
- 369
- Wydruki
- 2
- Wyświetlenia
- 2210
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The spacer prevents the PTFE tube from scratching the cover. However, as all the spacers I found were made of four individual parts or had to be glued, I created a version where you can attach two parts together with a dovetail and also detach them again. In addition, the spacers I used were all too big or too small. I therefore adjusted this spacer a little so that it fits me very well.
I printed the spacer with PETG. Both my printer and the filament are calibrated.
The left and right parts have to be printed twice each.
There is a gap of about 5mm between the left and right sides to facilitate alignment and to compensate for tolerances during printing.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Filament: Sunlu PETG
black
Category: 3D Printer Parts