Qidi Q1 Pro - top spacer with dovetail (no gluing necessary)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The spacer prevents the PTFE tube from scratching the cover. However, as all the spacers I found were made of four…
- Rating
- 3.75 / 5
- Likes
- 35
- Downloads
- 369
- Makes
- 2
- Views
- 2,211
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
The spacer prevents the PTFE tube from scratching the cover. However, as all the spacers I found were made of four individual parts or had to be glued, I created a version where you can attach two parts together with a dovetail and also detach them again. In addition, the spacers I used were all too big or too small. I therefore adjusted this spacer a little so that it fits me very well.
I printed the spacer with PETG. Both my printer and the filament are calibrated.
The left and right parts have to be printed twice each.
There is a gap of about 5mm between the left and right sides to facilitate alignment and to compensate for tolerances during printing.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Filament: Sunlu PETG
black
Category: 3D Printer Parts