Ender 3 Neo Heatsink Fan Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Heatsink block fan holding bracket for Ender 3 neo series.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 98
- Wydruki
- 0
- Wyświetlenia
- 779
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I've been wanting to get rid of that dysfunctional piece of plastic for a long time and finally did it without bothering, but I admit it could have been done better. The stock holder inhibits the airflow of the blower fan and weighs a few grams more. This apparatus may cause problems in the long run or may break or damage your printer, so I do not accept responsibility. It is recommended to print with heat tolerant filaments such as ASA, ABS or PETG. I used PETG. I printed with a 90 degree angle and there was no problem, if you have a problem, you can try printing with a 15 or 45 degree angle. I tightened the screws to the end and it is still one piece. I must say that I used these two grabcad models and they made my job very easy:
https://grabcad.com/library/ender-3-v2-neo-heat-sink-1
https://grabcad.com/library/40mm-fan-8
Thanks.
Note: I prepared this part according to the calibre of my own printer, your printer may give up to ± 3% error.