Ender 3 Neo Heatsink Fan Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Heatsink block fan holding bracket for Ender 3 neo series.
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 98
- Makes
- 0
- Views
- 779
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Public Domain
I've been wanting to get rid of that dysfunctional piece of plastic for a long time and finally did it without bothering, but I admit it could have been done better. The stock holder inhibits the airflow of the blower fan and weighs a few grams more. This apparatus may cause problems in the long run or may break or damage your printer, so I do not accept responsibility. It is recommended to print with heat tolerant filaments such as ASA, ABS or PETG. I used PETG. I printed with a 90 degree angle and there was no problem, if you have a problem, you can try printing with a 15 or 45 degree angle. I tightened the screws to the end and it is still one piece. I must say that I used these two grabcad models and they made my job very easy:
https://grabcad.com/library/ender-3-v2-neo-heat-sink-1
https://grabcad.com/library/40mm-fan-8
Thanks.
Note: I prepared this part according to the calibre of my own printer, your printer may give up to ± 3% error.