Silica Trap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Traps silica in the tray!
- Ocena
- 4 / 5
- Polubienia
- 12
- Pobrania
- 77
- Wydruki
- 3
- Wyświetlenia
- 691
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was tired of cleaning after taking the tray out of the dry box.
Every time I needed to refresh the silica gel, it violently jumped outside, so I made a lid it!
The lid
The original tray was filling the bottom of the dry box pretty nicely, so I just wanted to keep the silica inside in one place.
I've added grabbing points on the sides to make it easier to separate the two models apart.
The lid is held in place by the friction on the grabbing points of the tray so both the tray and the lid must be printed pretty precisely to make a good fit.
My recommended settings: 0.15mm layer height in Quality setting on 0.4 nozzle.
Material doesn't matter, I used PLA here.
The tray
I liked the new grab points introduced by Scott in his version of the tray so I left them in place just made a little longer. I cut it flat 😊 as it was no longer necessary.
If you like the original version more, just print the lid; sizing is the same, both will fit.