Solderless (*) DIY SlimeVR tracker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SlimeVR trackers built with off-the-shelf parts and standard cabling. No soldering needed for main VR tracker.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 1394
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Share Alike
Custom case for my DIY SlimeVR trackers. The main tracker sits in a 3-part box with a variety of ways to put a velcro strap or other attachment through it. The electronics all come from Adafruit.
* No soldering is needed on the main tracker. The optional aux tracker needs one little dot of solder to set the address of the second IMU.
Photos might show a slightly earlier draft with fewer slots for straps. The OpenSCAD files are included so you can modify to suit your parts and mounting needs.
More details in my blog, but here's the short BoM from Adafruit:
- Microcontroller dev board: Adafruit ESP32-S3 Feather with 4MB Flash 2MB PSRAM - STEMMA QT / Qwiic
- IMU board (one main and one aux): Adafruit TDK InvenSense ICM-20948 9-DoF IMU
- Microcontroller to main IMU cable: STEMMA QT / Qwiic JST SH 4-Pin Cable - 50mm Long
- Main IMU to Aux IMU cable: STEMMA QT / Qwiic JST SH 4-Pin Cable - 300mm long
- Battery: Lithium Ion Battery - 3.7V 2000mAh