Bolt The OpenSauce Mascot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Excited for this year's OpenSauce so I brought "Bolt" the mascot to life in both finger puppet and bobblehead form!
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 369
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Excited for this year's OpenSauce so I brought "Bolt" the mascot to life in both finger puppet and bobblehead form!
Fan art only. Just for fun, not affiliated with OpenSauce. Just a fun model to commemorate the fun and creativity that is the OpenSauce. If you plan to attend will have some for giveaways at the Prusa booth or feel free to make your own!
Directions:
PLA or PETG recommended. 2 perimeters, 0.2 layer height, 15% LIGHTNING INFILL!
Head First
Attach the antennae by simply cutting approximately 1" long strip of filament of your choosing and plug into the holes on the ears and energy dome. Press fit the antennae knobs on top. If you're particularly aggressive in your puppetry or bobbleheading consider a dab of superglue or similar to hold your antennae in place.
Finger Puppet Mode
Once head is assembled per above instructions for best results place on middle finger and one claw on each of your index and ring fingers. Make appropriate “*beep *blorp” noises while roboting around the room and pestering other humans and animals. Bonus points if you are able to sneak attack the claw onto someone else's septum for pretend robo piercing. (wash boogers off thoroughly afterwards)
Bobblehead Mode
Print optional stand or “BuffBoltBody” for fun little desktop toy. Designed to use these cheap bobblehead springs from Amazon.
https://www.amazon.com/dp/B09YNMDX6N
Press fit or dab of superglue on the end for extra aggressive bobbling.