Bolt The OpenSauce Mascot

Excited for this year's OpenSauce so I brought "Bolt" the mascot to life in both finger puppet and bobblehead form!

Fan art only. Just for fun, not affiliated with OpenSauce. Just a fun model to commemorate the fun and creativity that is the OpenSauce. If you plan to attend will have some for giveaways at the Prusa booth or feel free to make your own!

Directions:

PLA or PETG recommended. 2 perimeters, 0.2 layer height, 15% LIGHTNING INFILL!

Head First

Attach the antennae by simply cutting approximately 1" long strip of filament of your choosing and plug into the holes on the ears and energy dome. Press fit the antennae knobs on top. If you're particularly aggressive in your puppetry or bobbleheading consider a dab of superglue or similar to hold your antennae in place.

Finger Puppet Mode

Once head is assembled per above instructions for best results place on middle finger and one claw on each of your index and ring fingers. Make appropriate “*beep *blorp” noises while roboting around the room and pestering other humans and animals. Bonus points if you are able to sneak attack the claw onto someone else's septum for pretend robo piercing. (wash boogers off thoroughly afterwards)

Bobblehead Mode

Print optional stand or “BuffBoltBody” for fun little desktop toy. Designed to use these cheap bobblehead springs from Amazon.

https://www.amazon.com/dp/B09YNMDX6N

Press fit or dab of superglue on the end for extra aggressive bobbling.