Creality K1C Sidemount Spoolholder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a spoolholder for the Creality K1/K1C that moves the spool to the side.
- Ocena
- 5 / 5
- Polubienia
- 60
- Pobrania
- 632
- Wydruki
- 1
- Wyświetlenia
- 2359
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Introduction:
This is a redesign of the spoolholder for the Creality K1C that creality provides.
This design innately uses more walls and less infill. This provides better strength and uses the same amount of material as the original one. Furthermore the knobs for the twist in roll are easier to support for the printer.
Using the original filament sensor with this mod will be a bit more inconvenient, so I made a sidemounted sensormount for the BTT SFS 1.0:
https://www.printables.com/model/911340-btt-sfs-10-sidemount-for-the-creality-k1k1c
I have also included the hole measurements in a screenshot if anybody wants to make their own design.
Print Materials and Settings:
PLA - not recommended, but works fine as long as chamber temps don't get above 50° C
PETG - suitable as long as chamber temps don't get above 70° C
ABS - the best choice, perfect for heated chambers
Infill - 15-20%
Supports - Necessary, ideally tree supports
Walls - 3-4
Top and Bottom Layers - 3-4
Other Materials:
Three M3 x 8mm machine screws