1 / 2
Multiboard Sabrent 10-Port USB holder (HB-BU10) Revised — zdjęcie 1
1 / 2

Multiboard Sabrent 10-Port USB holder (HB-BU10) Revised

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A bracket for holding the Sabrent 10-Port USB hub (HB-BU10) compatible with mounting on the Multiboard system.

Ocena
0 / 5
Polubienia
1
Pobrania
19
Wydruki
0
Wyświetlenia
244
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A bracket for holding the Sabrent 10-Port USB hub (HB-BU10) compatible with mounting on the Multiboard system.

It was revised so that it occupies two fewer hexagonal spaces, and provides better viewing and access when mounted in the periphery.

The original model and the 1st remix are thin and flexible on the long sides, lending to the ease with which you can insert and remove the hub, given the added flexibility of the tabs.

This model has a solid body, so it becomes necessary to kind of slide the hub in from the high side. It will firmly click into place. The best way to remove it is to gently open the wider tabs and slide it back out. 

The degree of the flexion of the tabs is decreased, given the above reasons, so be careful not to snap them. Probably helps if you filament hasn't absorbed moisture.

Despite that, these hold the hub quite securely – both to the bracket and the Multiboard tile.

Secured into place with 9mm bolts.

Printed in PLA, 15% with 3 walls.

Tagi