XL MCU Sandwich / buddy cover with fan and filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on a cover, ready for a filter on air input and 40x40 fan. No more Buddy MCU overheat error!
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 61
- Wydruki
- 2
- Wyświetlenia
- 1074
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
After having a lot of crashes, I finally understood that one of the updates did actually put a lot more stress on the boards, indeed increasing temps there.
After a few research, I found a few covers on printables, but none matches my expectations, who were:
- keep the parts that holds the boards in position
- fan have to be at the higher pos
- air that enters the volume have to be filtered
Suggested Filter: https://amzn.eu/d/haqWow8
Suggested Fan: https://amzn.eu/d/hPzgNja
Suggested protection : https://amzn.eu/d/4TuqKG8
Fan can be connected directly on the board: just use the 24V input right behind the left cover, and let the wires go this way. Check Pictures!
Due to temp, I felt confortable to print this in Prusament PC, ABS or ASA would work, Not sure about PETG, and definitely no to PLA.