Aaron Park's Flexible Spiral Fidget Wheel Toy with revised sides
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
flexible wheel fidget toy for spinning, rolling and bending (revised)
- Ocena
- 4 / 5
- Polubienia
- 19
- Pobrania
- 157
- Wydruki
- 1
- Wyświetlenia
- 1724
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I like the fidget spinner from Aauron Park, but the sides didn't quite work for me, because the were rubbing against the bearing causing friction, so I set out to redesign the Parts in Fusion360 as a challenge (my first design).
basically I made them bigger and added a collar. Also I tried to improve the fit.
I also attached the original wheel for your convince, which I didn't modify and I am also referencing a few key aspects form his description here:
somewhere between a squish toy and a fidget spinner. Printed in TPU, the spiral blades are quite flexible and can be bent or crushed in a variety of ways. A 22mm bearing is contained within the center of the wheel, allowing the user to spin the device freely or roll it on surfaces. There are different characteristics for each direction of motion too. Plenty of ways to fidget with this toy!
~60mm diameter (~40mm when compressed) and 15mm tall
Tips and Tricks:
- uses 1x 608 Skateboard Bearing (22mm O.D. x 8mm I.D. x 7mm tall)
- the stock lubrication of these bearings is usually pretty thick. If your bearing doesn't spin well, try to get some lighter oil inside the bearing rings such as Brunox or Balistol (Rubber seals (RS) can be removed carefully while metal shields (ZZ) are typically non removeable, but you can spray into the gaps)
- print the wheel with tree supports to support the inner lip
- make sure to have sufficient z-spacing for the supports (Top contact Z distance) I recommend 0.3 mm for TPU
- print slow, especially the pins of the caps
- dry your filament
my print settings (Extrudr semi soft 85A)
- print speed 2–20 mm/s
- print object separately or sequentially
- organic supports for wheel
- support top contact Z distance 0.3mm
- 0.2 mm layer height, but others will also work
- 10% gyroid infill
looking forward to hear your feedback
