70mm Wobbler Lure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fishing lure for shallow to medium depth, slow sinking (if printed right), with amazing action
- Ocena
- 5 / 5
- Polubienia
- 72
- Pobrania
- 634
- Wydruki
- 2
- Wyświetlenia
- 2455
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
As featured in:
To assemble the lure you need:
- 5x 5mm stainless steel balls
- 3 twist wires using 0.8mm stainless steel wire
- 5mm eye
If you have a different size wire or screw eyes and they do not fit, send me a message and I'll upload a new version (communication is faster on Discord)
In the slicer (Bambu studio or Orca slicer) rotate the model to the following angles:
x: 234
z: 180
Go to support painting tool, set the highlight threshold to 80-83 degrees, enable on overhangs only, and using the fill tool fill the back side of the lure only
Print parameters:
Quality:
- Seam position: back
- Wall generator: Arachne
- Order of walls: inner/outer/inner
Strength:
- Walls: 3
- Infill density: 10%
- Infill pattern: Gyroid
Speed:
- Outer wall: 60
Support:
- Enable support: Enabled
- Type: normal(manual), this is equivalent to grid support
- Base pattern spacing: 1
- Independent support layer height: disabled
These settings are for PLA, if you are using ABS or any other material, adjust the walls and infill till you get to a point where the lure body is about 6-6.5 grams
Join my discord server for discussions related to 3d printed fishing projects: https://discord.gg/qmRwEuvpnC
If you want to support my work, consider joining my club or buy anything related to 3d printing using my affiliate links:
International: https://www.awin1.com/awclick.php?gid=404404&mid=21809&awinaffid=1565514&linkid=2790717&clickref=printables