Y-Axis Limit Switch Bracket For Elegoo Neptune 2S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement Y-axis limit switch bracket, for when the original one is starting to show cracks or keeps falling out.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 38
- Wydruki
- 1
- Wyświetlenia
- 227
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Y-axis limit switch bracket of my printer was starting to show cracks, so I designed this one. It has a little block on the back to keep the threads that go into the extruded profiles semi-aligned, so the bracket goes in much easier than the original.
The screw holes for the PCB are a little too small by design, so those will need to be drilled out, or alternatively you could melt in the screws with a soldering iron.
I used PLA+ with a 220c nozzle temp and 55c bed temp, with the largest flat side to the buildplate, no supports.
I used 3 perimeter walls, which makes it pretty much solid due to the size. 2 perimeter walls with a 15% infill is probably fine too.