1 / 4
Hobby plus Convoy / Absima CR-18 Servo winch and mount — zdjęcie 1
1 / 4

Hobby plus Convoy / Absima CR-18 Servo winch and mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fully functional winch for a 1/18th scale RC crawler. Should fit all Hobby Plus / Absima 1/18th scale trucks.

Ocena
0 / 5
Polubienia
4
Pobrania
56
Wydruki
0
Wyświetlenia
452
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

I wanted a functional winch for my 1/18th scale mini-crawler, and designed this winch spool and mounting bracket for the Hobby Plus CR-18 truck I have. As long as the bumper mount hole pattern and frame width is the same, it should fit all CR-18 trucks I believe. 

Proof in pudding: https://www.instagram.com/p/C8ZeM85o49l/?img_index=3

The winch spool is assembled using some cut-offs of 1.75 filament as index pins, and glued with super glue. It should fit straight onto a 9g servo axle, using an original servo horn screw. 

The replacement bumper mount is also reusing original hardware, as well as using some bits of filament to replace the small 2mm index pins. 

The pictures here should give you an idea of how the parts go together. I secure the servo to the mount using a 2.5mm zip-tie :) So no additional hardware required! (Unless you need to swap out your receiver to get a 3rd channel.. But that's something you need to source yourself!)

 

As winch wire, I have temporarily used a high-strenght sowing thread, and I bent a paper-clip to make a hook. I secured the thread to the spool by tying it to a 2mm nut after threading it out the little hole in the spool. 

Tagi