Powerbar vertical stand/holder for Unitec Powerstrip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screwable vertical stand for the Unitec powerstrip with cable channel on the back
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 166
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a stand which allows to mount this aftermarket powerstrip vertically. I got it from my local convenience store, but it is sold as a brand “unitec” switched power strip on amazon.
It slots into the mount with the cable facing downwards. Below the shelf that it sits on, there is a chamber for the cable to go through with a hole on the back, as well as some screw tabs to secure it to a table.
If you plan on doing that however, make sure to route the cable first, otherwise you won't get it in later.
The frontal cutout is designed to fit exactly where the switch is going.
You can see the exact dimensions of the slot on the picture. However, this power strip is still gonna have some play as it's not completely flat.
For now, it's doing it's job just fine for me, but if it is required, the things I've noted for a potential V2 are:
- Deeper slot for the strip to hold with less wobble (Go completely over the overvoltage light, add a cutout)
- Put screw tabs in every corner to prevent from falling over forwards/backwards
- Add a “clip” to the slot to hold the powerbar more tightly
- An end cap. Just for the style.
- Maybe some screwholes to hold it in even tighter? (Dangerous!!)