Separatable Pinecil case optimized for soldering on the go
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Updates to Termiman's Pinecil case to add a few things I wanted.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 474
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I really liked the idea of Termiman's Pinecil case, but there were a several changes I wanted. These are my changes.
- Moved around the accessory storage to keep the soldering iron on the right as I am right handed.
- Made the brass sponge holder removable to make it easier to empty of debris.
- Left the flux section open to be customizable via foam for either a syringe or a pen.
- Added extra tip storage.
- Removed USB cable storage. I am often traveling with one anyway.
- Added half-pin hinge so that the two sides can be separated to more easily set up my work area.
- Magnet holder for Pinecil sleep mode mod (https://wiki.pine64.org/wiki/Pinecil_Hall_Effect_Sensor)
Additional parts needed:
- 1 608 bearing
- 4 6x3 magnets (2 for the latch and an optional 2 for the iron holder to trigger sleep mode (see below)
- 2 4D nails for the hinges
The soldering iron holder uses a 608 bearing and uses 6x3 magnets (1 or 2 depending on the strength required for your iron) to trigger sleep mode in the Pinecil. Sleep mode requires a mod (https://wiki.pine64.org/wiki/Pinecil_Hall_Effect_Sensor) to add a hall effect sensor in order to detect the magnets.
For the half pin hinge, I used 4D finishing nails. I cut the back off and filed the tip to be rounder and safer before pressing them into the case. Additional 6x3 magnets are used instead of a latch.