Hex socket adapter 1/2inch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
'lil adapter that allows to drive the screws without any torque.
When I change the tires, there is always 4*5 screws to tighten. Each one with 20 turns.
OMG 400 TURNS. :)
All done by hand. And after that they are to tighten up to the specific torque.
This obviously needs some 3D printed solution. You could certainly buy that part…
This piece is to lightly screw in those screws without applying some torque. In order not to break the print, the part that goes in the chuck is round.
The part has built in supports. Print as shown with additionally supports from your slicer if you need them.
Remove all the suports.
Made for drill chucks that go up to 10 mm.