1 / 6
Ender 3 V3 Top Filament Sensor Mount (work in progress) — zdjęcie 1
1 / 6

Ender 3 V3 Top Filament Sensor Mount (work in progress)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Filament Sensor Top Mount for Ender 3 V3

Ocena
0 / 5
Polubienia
4
Pobrania
48
Wydruki
0
Wyświetlenia
409
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The Ender 3 V3 is a great printer. The only drawback is the filament feed from the side. If you can do without the runout sensor, the filament can also be fed in from the top. However, I wouldn't want to do without it, especially for very long prints. So I built this holder.

The holder has two holes so that it can be attached to the frame. I used two M3x20 screws for this (shorter ones would certainly work too, I just didn't have any left).

The bracket is not yet finalized, I have some problems to find the exact distances for the holes to attach the sensor. Practice makes perfect.

It can still be used if you screw the screws in with a little force.

To make the sensor work, it is necessary to extend the cable. You will need two JST HX 3 pin connectors, some cable and a few pins. If, like me, you have two left hands for soldering, you can also use solder connectors (like these here: https://amzn.to/4exZmUV ). 

 

I printed my holder with PETG. But since there is not a lot of stress or heat involved, PLA should also work.

When printing, I activated 15% infill and support.

If I find time, I will improve the problem with the holes.

 

Changelog:

 

2024/06/23

First public release

 

Tagi