3DO nozzle cam V2 setup for Ratrig toolhead VC4 VC3.1 and EVA 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
bolt on kit to add a nozzle camera to your V-core 4 printer. you are reusing the M3 screws from the original shroud.
- Ocena
- 5 / 5
- Polubienia
- 76
- Pobrania
- 312
- Wydruki
- 2
- Wyświetlenia
- 3894
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
update..
added the Chube mount.
Disclaimer!! use at own risk (the camera is pretty close to the hotend)
update…
corrected the focus distance for VC3.1 RR toolhead and EVA 3 (November 24.)
added the body for VC3.1 RR toolhead and EVA 3 short standard (November 24.)
added the body for V-Minion 1.1 RR toolhead (November 24.)
added the body for VC3.1 RR toolhead and EVA 3 (October 4.)
!!!!!!only works for V2 nozzle camera from 3DO !!!!!!!!
this mount is made for this camera from 3DO
3DO Nozzle Camera Kit V2 - Sony 4K for 3D Printers
remember to chose 10cm FPC
BOM
4pcs short M3 heatinserts
2pcs M3x10/12 (both lengths work) for the clamp
2pcs M3x8/10 (both lengths work) for the cover
Assembly
insert heat inserts
put in FPC cable
slide camera into position
mount the clamp ( be careful not to damage the camera/lights)
gently fold the excess FPC under the PCB plate
and mount the cover on top of PCB
Attention!!
put FPC cable in one notch at a time without damaging it.
if you want to remove FPC cable, then slide in a zip-tie underneath and gentle pop it out
VC4 is tested
EVA 3 is tested ( may need longer screws for mounting )
VC3.1 is untested