1 / 4
Toolbox for Prevention of a Z-Axis Crash — zdjęcie 1
1 / 4

Toolbox for Prevention of a Z-Axis Crash

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I almost happened to have a z-axis crash while the "camera box" touched something too close to the right side of printer

Ocena
0 / 5
Polubienia
1
Pobrania
15
Wydruki
0
Wyświetlenia
215
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I liked the cable guide right besides my Bambu Lab A1 printer: https://www.printables.com/de/model/903605-cable-guide-a1-bambulab/comments/1865280 

Since I reorganized the setup (AMS lite on top mount) and place of the printer I ran risk of getting something obstacle too close to the printer, and if this exceeds some 90 or 100mm the z-axis touches this obstacle and lifts the right end to the printer up. No imagination about what all can happen then …

So I made this toolbox to sit it right in the corner of the right z-beam. A.m. cable guide was to bypass. So I set the rear part of the box 30mm higher, with a quarter cylinder to let the cable air to breathe. Works fine.

Note, do not to put something into the box that exceeds the max height.

Additionally I printed a Bambu Lab Logo plate which I glued into the front side of the box. Three colors: grey, dark grey, green.

Explore my other Printables: https://www.printables.com/de/@Tritschi 

Enjoy and Happy printing.

Tagi