Toolbox for Prevention of a Z-Axis Crash
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I almost happened to have a z-axis crash while the "camera box" touched something too close to the right side of printer
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I liked the cable guide right besides my Bambu Lab A1 printer: https://www.printables.com/de/model/903605-cable-guide-a1-bambulab/comments/1865280
Since I reorganized the setup (AMS lite on top mount) and place of the printer I ran risk of getting something obstacle too close to the printer, and if this exceeds some 90 or 100mm the z-axis touches this obstacle and lifts the right end to the printer up. No imagination about what all can happen then …
So I made this toolbox to sit it right in the corner of the right z-beam. A.m. cable guide was to bypass. So I set the rear part of the box 30mm higher, with a quarter cylinder to let the cable air to breathe. Works fine.
Note, do not to put something into the box that exceeds the max height.
Additionally I printed a Bambu Lab Logo plate which I glued into the front side of the box. Three colors: grey, dark grey, green.
Explore my other Printables: https://www.printables.com/de/@Tritschi
Enjoy and Happy printing.