Chair Stop 60mm and 50mm for Simracing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Chair stopper for office chairs with 60mm or 50mm diameter wheels. Gap between the wheels is 20mm.
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 551
- Wydruki
- 4
- Wyświetlenia
- 1519
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
2025-04-13: Added Version for 50mm wheels. Gap between the wheels is still 20mm
The Chair stopper stops your office chair from rolling away. I specially designed thi to use my office chair for simracing.
The Stopper fits 60mm diameter wheels. The Gap between the wheels is 20mm.
Glue a cork mat or rubber to the bottom of the stopper for best results.
WARNING: If the “cross” of your chair is made out of plastic, it might get bent or even break if you only use two stoppers. In that case you should use a stopper for each wheel.
Print Settings
Printer:
Geetech A10pro
Rafts:
No
**Supports:**
No
Resolution:
0.2
**Infill:**
10% Lines/Grid
Filament: Giantarm PLA Silk Grey
Notes:
I Printed with 10% Infill type Lines.
Just make sure, that there is no infill below the deepest point of the wheel.
Thats why i Printed with 4 Bottom and 7 Top layers.
Settings are attached
Category: Office