Chair Stop 60mm and 50mm for Simracing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Chair stopper for office chairs with 60mm or 50mm diameter wheels. Gap between the wheels is 20mm.
- Rating
- 5 / 5
- Likes
- 29
- Downloads
- 551
- Makes
- 4
- Views
- 1,519
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
2025-04-13: Added Version for 50mm wheels. Gap between the wheels is still 20mm
The Chair stopper stops your office chair from rolling away. I specially designed thi to use my office chair for simracing.
The Stopper fits 60mm diameter wheels. The Gap between the wheels is 20mm.
Glue a cork mat or rubber to the bottom of the stopper for best results.
WARNING: If the “cross” of your chair is made out of plastic, it might get bent or even break if you only use two stoppers. In that case you should use a stopper for each wheel.
Print Settings
Printer:
Geetech A10pro
Rafts:
No
**Supports:**
No
Resolution:
0.2
**Infill:**
10% Lines/Grid
Filament: Giantarm PLA Silk Grey
Notes:
I Printed with 10% Infill type Lines.
Just make sure, that there is no infill below the deepest point of the wheel.
Thats why i Printed with 4 Bottom and 7 Top layers.
Settings are attached
Category: Office