1 / 11
Soda Stream Aqua Fiz base for older cylinders — zdjęcie 1
1 / 11

Soda Stream Aqua Fiz base for older cylinders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A base to lift your Soda Stream Aqua Fiz enough to fit legacy cylinders with an adapter.

Ocena
0 / 5
Polubienia
2
Pobrania
12
Wydruki
0
Wyświetlenia
222
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Old Soda Stream “screw on” cylinders do not work with newer Soda Stream “Aqua Fiz”. This new model was designed for the “screwless”, quick-release type of cylinder. To fix this you may purchase an adapter, which do work, but they extend the height of the cylinder making it no longer fit the Aqua Fiz unit.

This 3d print model is designed to lift the Aqua Fiz off of your counter/table high enough to fit the older cylinder outfitted with such an adapter.

To use this model it requires that you drill a hole in the Aqua Fiz base large enough for the cylinder to poke through the bottom.

This model comes in 2 parts (it was too large for my print bed). I have had success printing out 2 of the assembly pegs and gluing them into the assembly holes (I used Gorilla super glue).

To use this model:

  1. Print the base, cylinder floor and 2 assembly pegs
  2. Assemble the base and cylinder floor by gluing the pegs into the holes on the floor & base
  3. You need to slightly disassemble the Aqua Fiz base:
    1. Lie the Aqua Fiz on its side so you can access the bottom of the unit.
    2. Remove the retaining clip (shown as blue in the image) from the bottom of the Aqua Fiz. This may be difficult, but you can use a small flathead screwdriver to push the clip out. Make sure you are ready to catch it because it is under tension thus may fly out!
    3. Remove the 4 retaining screws (shown in red in the image).
    4. Now remove the bottom base from the Aqua Fiz.
    5. Using a small saw or a drill (I used a 2.5" hole saw drill bit) cut out the bottom of the round area that would be just below the cylinder when it is standing upright. There is an image that shows this part already removed.
    6. Now reattach the base back to the Aqua Fiz:
      1. Screw in the screws from step 3
      2. Adjust the metal pole which the retaining clip holds in place (from step 2) such that it is pushed through the bottom hole so that you can reapply the clip to hold it in place. For this needle nose plyers were really helpful, along with a flathead screwdriver.
    7. Stand the Aqua Fiz unit on top of the printed/assembled base you printed!
    8. Now go and enjoy a carbonated beverage!

Tagi