Milwaukee M12 Fuel Installation Drill/Driver bit holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a four bit holder for the Milwaukee 2505-20 M12 Fuel Installation Drill/Driver
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 230
- Wydruki
- 1
- Wyświetlenia
- 1045
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this to be used with the Milwaukee 2505-20 M12 Fuel Installation Drill/Driver. However, it could work with any Milwaukee tool which uses the same belt clip, but the angle, when installed, may not work for some tools.
I printed with a 0.6 nozzle for the part in the pictures, but I recommend using a 0.4mm nozzle with 0.2 Layer Height, 100% Infill, and 4 Wall Loops.
The holes, which have a 7.5mm diameter, are just big enough for the bits to fit in easily and should have a 6x2mm magnet glued into them at the bottom to hold the bits securely. If you want a friction fit instead of using a magnet, use Fuzzy Skin with a 0.3/0.3 setting, making sure to use All Walls or Contour and Holes (may need some experimenting with the FS settings for your specific printer).
The screw size is a #6-32. If you use a flat head with a washer, as I did, you need a ¾in length. If you want to use a button head screw you'll need to use a ½ in length.