Milwaukee M12 Fuel Installation Drill/Driver bit holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a four bit holder for the Milwaukee 2505-20 M12 Fuel Installation Drill/Driver
- Rating
- 5 / 5
- Likes
- 40
- Downloads
- 230
- Makes
- 1
- Views
- 1,045
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this to be used with the Milwaukee 2505-20 M12 Fuel Installation Drill/Driver. However, it could work with any Milwaukee tool which uses the same belt clip, but the angle, when installed, may not work for some tools.
I printed with a 0.6 nozzle for the part in the pictures, but I recommend using a 0.4mm nozzle with 0.2 Layer Height, 100% Infill, and 4 Wall Loops.
The holes, which have a 7.5mm diameter, are just big enough for the bits to fit in easily and should have a 6x2mm magnet glued into them at the bottom to hold the bits securely. If you want a friction fit instead of using a magnet, use Fuzzy Skin with a 0.3/0.3 setting, making sure to use All Walls or Contour and Holes (may need some experimenting with the FS settings for your specific printer).
The screw size is a #6-32. If you use a flat head with a washer, as I did, you need a ¾in length. If you want to use a button head screw you'll need to use a ½ in length.