1 / 5
Braze on FD washer
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
replacement washer that uses CSK fastener instead of typical CBORE
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 101
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Design
- as of 2024-06-30, this hasn't been tested or probably will get tested or printed by me until I need it
- based in part off of an aluminum washer that came with a Shimano FD-5800
- this washer uses a CBORE screw
- this version, since it is 3DP, would benefit from a CSK instead
- the rear curve comes from the braze on standard geometry
Hardware
- Shimano Tiagra FD, probably FD-4400 or thereabouts, measures 13.25 mm deep, including the thickness of the braze on bracket – consequently the intended fastener for my application is about 18.25 mm max; probably closer to 12-14 due to material thickness
