1 / 5
Cole Jaw Bumpers for wood lathe chucks: Nova, VicMarc, etc. — zdjęcie 1
1 / 5

Cole Jaw Bumpers for wood lathe chucks: Nova, VicMarc, etc.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Variant shapes, sizes, and hardnesses of M6 cole jaw bumpers for common wood lathe chuck brands like Nova, VicMarc, etc.

Ocena
0 / 5
Polubienia
27
Pobrania
166
Wydruki
0
Wyświetlenia
705
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

IMPORTANT! I heard from a friend that his set were loose, and asked him to show me. Turns out he was using an entirely different set of screws. This was dangerous on his part. Remember that using power tools can be dangerous, even life threatening... Please read all instructions below, and on your jaws, tools, and lathe.

Variant shapes and sizes of cole jaw bumpers for common wood lathe chuck brands like Nova, VicMarc, or others that use an M6 post.

I initially had trouble getting the TPU/FLEX to print consistently, so I included my 3mf project files and Prusa MK3S gcodes for each variant. The main lessons learned were A) 0.1mm layers work better than larger layer heights, and B) make sure your temps are dialed it... I was originally printing my TPU several degrees too hot!

I learned the “smaller layer lines” lesson after the wide bumpers were printed and photographed, so you may want to try that 3mf file at 0.1mm instead of the included 0.2mm. The smaller TPU/FLEX dovetail project and gcode is already 0.1.mm. 

1. Use the right screws.
2. Never use PLA for critical parts as it's subject to layer sheer.
3. Print a suitable number of perimeters and infill for your material.
4. Turn at your own risk.

All bumper variants listed use this shoulder screw from McMaster-Carr. Verify your Cole Jaws are threaded M6 and order at least one set of 8.

Alloy Steel Shoulder Screws
8 mm Shoulder Diameter, 25 mm Shoulder Length, M6 x 1 mm Thread

If you're going to print multiple variants of the TPU/FLEX bumpers, I recommend ordering multiple sets of the screws, because getting the flexible bumpers off the screws can take more effort that is convenient during a project. If you print the bumpers with a harder material like PETG or ASA, a single set of screws may be sufficient.

Tagi