Bumpers for the Storm 2 Powerbank
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Soft bumpers for the STORM2 Powerbank to offer fall protection and distance from surfaces avoiding scratches or damage.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 437
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
About
So i got this powerbank on Kickstarter, and it was really cool, except the part about how the acrylic outer shell can get scratched really easily. And scratch it i did the first time i was using it outside.
So after i asked the manufacturer, they were nice enough to send me a STEP of the outer parts (not sure if i can share those), which made it a lot easier to create these bumpers.
Settings
Printed using Prusa i3 MK3S on the textured spring steel sheet with extrudr Flex Semisoft (85A) Transparent with these settings:
Layer Height: 0.3mm
Infill: Gyroid
Infill Density: 6%
There is an official Prusa profile for the material used, but i used an older one adapted on DAS FILAMENT TPU, which uses 2mm retracts.
Try scaling the model down a fraction of a percent i think i used 99.7%
Material with a shore hardness of 95A likely works just as well but i haven't tried it.
License
Attribution-ShareAlike 4.0 International (CC BY-SA 4.0)
Free to modify and republish with credits and the same license
- Applies to photos as well
- Does not apply to some components of the fusion 360 file that are owned by the owners of the STORM2 Project
- Optional: If this was of use to you or if you made something based on it please tell me about it!