Bumpers for the Storm 2 Powerbank
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Soft bumpers for the STORM2 Powerbank to offer fall protection and distance from surfaces avoiding scratches or damage.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 30
- Makes
- 0
- Views
- 437
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
About
So i got this powerbank on Kickstarter, and it was really cool, except the part about how the acrylic outer shell can get scratched really easily. And scratch it i did the first time i was using it outside.
So after i asked the manufacturer, they were nice enough to send me a STEP of the outer parts (not sure if i can share those), which made it a lot easier to create these bumpers.
Settings
Printed using Prusa i3 MK3S on the textured spring steel sheet with extrudr Flex Semisoft (85A) Transparent with these settings:
Layer Height: 0.3mm
Infill: Gyroid
Infill Density: 6%
There is an official Prusa profile for the material used, but i used an older one adapted on DAS FILAMENT TPU, which uses 2mm retracts.
Try scaling the model down a fraction of a percent i think i used 99.7%
Material with a shore hardness of 95A likely works just as well but i haven't tried it.
License
Attribution-ShareAlike 4.0 International (CC BY-SA 4.0)
Free to modify and republish with credits and the same license
- Applies to photos as well
- Does not apply to some components of the fusion 360 file that are owned by the owners of the STORM2 Project
- Optional: If this was of use to you or if you made something based on it please tell me about it!