6x9 Single Sheet film Developing Tank (ver 0.9)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Daylight film tank for single sheet, adjustable size. Not final product, but usable for testing.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 468
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
Testing version (I call it v0.9), some issues (read)
My design of minimum size (75ml) developing tank for one single sheet of 6x9. You can adjust the spool size - so it can fit 6,5x9 cm (European) or 2 ¼ x 3 ¼ in (US) sheet.
Daylight developing possible (lot of light traps, the same as JOBO tank).
No supports needed, just watch the notes - two parts you need to print upside down.
Use any cap from PET bottle and O-ring with 35mm / 45mm diameter.
The problems:
- Be sure you adjust print setting to be watertight. Mine printed from PLA (0.2mm layer, 5 shells) is leaking a little bit
- I went too far with minimising the design and film sheet is trying to jump off the reel :) so the usage is a bit tricky / complicated, be careful not to scratch the film. I advise you to train first, but I will probably make another - bigger version. Stay tuned.
I have used a great PET thread model from @steffanders, thank you very much!
https://www.printables.com/model/262018-pet-bottle-pco28-1810-thread-standard-models