6x9 Single Sheet film Developing Tank (ver 0.9)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Daylight film tank for single sheet, adjustable size. Not final product, but usable for testing.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 35
- Makes
- 0
- Views
- 468
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
Testing version (I call it v0.9), some issues (read)
My design of minimum size (75ml) developing tank for one single sheet of 6x9. You can adjust the spool size - so it can fit 6,5x9 cm (European) or 2 ¼ x 3 ¼ in (US) sheet.
Daylight developing possible (lot of light traps, the same as JOBO tank).
No supports needed, just watch the notes - two parts you need to print upside down.
Use any cap from PET bottle and O-ring with 35mm / 45mm diameter.
The problems:
- Be sure you adjust print setting to be watertight. Mine printed from PLA (0.2mm layer, 5 shells) is leaking a little bit
- I went too far with minimising the design and film sheet is trying to jump off the reel :) so the usage is a bit tricky / complicated, be careful not to scratch the film. I advise you to train first, but I will probably make another - bigger version. Stay tuned.
I have used a great PET thread model from @steffanders, thank you very much!
https://www.printables.com/model/262018-pet-bottle-pco28-1810-thread-standard-models