Foaming soap dispenser wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An after-market wall mount for an automatic foaming soap dispenser
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 120
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
This is a wall mount for the “P6 Automatic Soap Dispenser”. It already comes with a wall mount, but the mount is made out of some sort of extremely slick plastic that I can't get to stick to my double-sided VHB tape. This wall mount fixes that problem.
Printing
Any material. Slice as oriented in the model. Supports required.
I'd suggest a smooth bed, a print on a textured bed didn't stick to the VHB very well.
Assembly
Remove supports.
Sand the backside of the mount with sandpaper (grit doesn't really matter) until the entire surface is roughed up.
Apply a strip of VHB adhesive along the top, the full width of the mount. Apply two shorter strips of VHB adhesive down the sides.