Multiboard Makita cordless jigsaw holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A multiboard accessory for hanging a Makita cordless jigsaw (XVJ03 and possibly others)
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 67
- Wydruki
- 0
- Wyświetlenia
- 390
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A multiboard accessory for hanging a Makita cordless jigsaw. This fits my XVJ03, and probably works for other similar models. You must remove the blade before hanging the saw, and there is a small side compartment for storing blades.
Attaches to the board via 4 9mm flat-head big-thread bolts (print separately).
Printing
It is recommended to print in a 45 degree angle, to allow for maximum strength while minimizing or entirely eliminating support (I printed with a little bit of tree support as shown in the image but this is probably not required if you have good bed adhesion).
You can probably also print this standing up with no support but I suspect the result will be less strong.
It is recommended to use a strong filament with 3+ wall loops and 25% infill, as the jigsaw can be quite heavy and create stress on the hanger.
I printed with PETG, but you can probably use PLA or whatever you use for printing multiboard.io accessories.