mounting brackets for 25mm or 1" diameter tube led lights
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
i purchased a 250mm long 15mm round tube led light for under the bonnet (hood) of my car to provide some decent lighting
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 225
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
i modified the mount in two ways. one was adding holes for 8mm x 3mm magnets and also i reduced the locking screw size to M3 as these are what i had laying around.
i have also made a second variant that has a wider base to allow for 3M double sided tape to mount it to non magnetic surfaces.
the screw i used to lock the tube into position is an M3x8mm.
don't over tighten the screws. they are only meant to provide enough tension to stop the tube from falling out or rotating.
the tape mount type has a single layer that will have to be broken through for the screw hole.
this is a sacrificial layer required due to the hole, and for saving support material.
no support material is needed if printed at .2mm and 4 perimeters.
this will fit any 25mm or 1" round tube style led.
hopefully you find these useful.
i have orientated the STL files as they should be on the bed for printing
i used 4 perimeters and 25% support cubic infil.
for use in higher temperature applications, use PETG or ASA. otherwise PLA will work fine.